Cables for Interconnecting Automotive Oscilloscope

17$

TL-mlp Multipurpose Test Lead

In Stock

The multipurpose test lead is an integral part of an automotive oscilloscope. It allows you to evaluate output voltage and catch waveforms in car connectors, terminals and other circuits.

13$

TL-light Simplified Test Lead

In Stock

TL-light is the simplest probe for automotive scope. However, it performs the bulk of measurements in automotive connectors. Miniature size allows you to get to the most recessed areas.

18$

TL-AS-light Test Probe for the USB Autoscope IV

In Stock

The test probe for the USB Autoscope IV. It has the working area LED illumination, as well as two removable flexible pins, with the help of which performs the bulk of measurements in automotive connectors. Miniature size and lightweight allow you to get to the most recessed areas.

24$

TL-dif Differential Test Lead

AVAILABLE IN 1-2 WEEKS

The differential test lead offers oscilloscope channels galvanic isolation, allows safe, accurate measurement between two voltage points where neither is referenced to ground. Can be connected to crankshaft position sensor, electric generator windings, internal circuits of engine control unit.

28$

TL-mix4 Mixer Test Lead

In Stock

The mixer test lead can be connected to electromagnetic injectors, primary circuit or control signal of individual ignition coils. It allows you to record a signal from up to four sources at the same time, using only one analog input of the oscilloscope.

37$

TL-mix6 Mixer Test Lead

In Stock

The mixer test lead can be connected to electromagnetic injectors, primary circuit or control signal of individual ignition coils. It allows you to record a signal from up to six sources at the same time, using only one analog input of the oscilloscope.

10$

SP-flexpin-S Flexible Mini Probe Pins

In Stock

Probes are designed for connecting an oscilloscope to automotive connectors without having to use a break out box or damage the wire isolation as well as other recessed areas.

SP-flexpin-M Flexible Back-Pinning Probes

In Stock

Flexible probe needles are designed for connecting an oscilloscope to automotive circuits through the rear of the wiring loom connectors without having to use a break out box or damage the wire isolation as well as other recessed areas. Can be used with TL-dif, TL-mix4, TL-mix6 test leads.

SP-flexpin-L Flexible Back-Pinning Probes with long cable

In Stock

Flexible probe needles are designed for connecting a multimeter to automotive circuits through the rear of the wiring loom connectors without having to use a break out box or damage the wire isolation as well as other recessed areas. It has a length of 2 meters, which allows you to conveniently check the wiring harness. Can be used with TL-mlp, TL-dif, TL-mix4, TL-mix6.

SP-ac Alligator Clip Probes

In Stock

Good general-purpose clips are designed for connecting an oscilloscope to automotive circuits and connectors, allows clamping thin and thick wires up to 15 mm. Can be used with TL-dif, TL-mix4, TL-mix6 test leads.

SP-hook Test Hook Probes

AVAILABLE IN 1-2 WEEKS

Tester hook probes are designed for connecting an oscillograph to automotive wires, connectors, PCB pads and other recessed areas. Can be used with TL-dif, TL-mix4, TL-mix6 test leads.

18$

SP-ext banana plug double end wire extension

In Stock

Used as an extension cord while measuring signals by an oscillograph or multimeter. Can also be used as power cables for supplying voltage to different car units. Designed for current strength of up to 25 A. With a standard 4 mm banana plug, the extensions are compatible with all the test leads we produce.